007 james bond concrete tester for layers of materials


	Phone 773.463.6565 \| Toll-Free 800.426.6500 \| Fax 773.463.0009	Español

HOME

ONLINE CATALOG

STRENGTH TESTING

REBAR LOCATORS

ULTRASONIC & STRUCTURALTESTING

CORROSION TESTING

FRESH CONCRETE

MOISTURE TESTING

ROLL HARDNESS TESTING

CERAMIC MATERIALS TESTING

Special Offer!

Now offering 25% on any new W-D-2000 Digital Rebound Hammer with the
trade-in of any old, new, or abused rebound hammer.
Get in on this offer before it is too late, offer valid until
July 31, 2008.

007 James Bond Tester™ » Frequently Asked Questions

007 James Bond Tester™

REQUEST FOR QUOTE

Measures bonding strength between two layers of material.

Frequently Asked Questions

Q.	Bond disc will not stick to surface
A.	You may have not mixed epoxy fully and it won't dry.

Q.	Disc pops off surface at a low strength
A.	Surface may not have been cleaned properly. A good indication of this would be little bits of concrete stuck to the bottom of the disc. You may also not have a level surface.

Q.	When doing a test to check bonding strength on a roadway, do you have to take the test to failure?
A.	Yes and no. Make sure you follow the specs for each job you do, some may want you to take it failure, while others may want you to just take it to a certain strength.

Q.	When I crank the handle down, the gauge does not move.
A.	Chances are you need to fill the puller with oil.

Q.	How much epoxy do I put on the bond disc?
A.	You need just a thin layer, about 3 for 4 sheets of paper.

007 James Bond Tester™

Features & Benefits:

	Accurate bond strength of repair mortars, epoxy resin, laminates, overlays, and other coatings.
	Calibrated gauge with maximum load indicator.
	Viscose damping mechanism to protect against sudden load release.
	Adjustable alignment plate with built in leveling facility.
	Compact design.
	Easy to use.
	Conforms to BS-1881-207, ASTM: C-4541 and ACI:503-30.

Downloadable Files:

	Complete Data Sheets
	Instructions