| La Solidez de Unión Entre Dos Capas y la Solidez de Anclas se Miden.
Frequently Asked Questions
| Q. |
Bond disc will not stick to surface |
| A. |
You may have not mixed epoxy fully and it won't dry. |
| |
|
| Q. |
Disc pops off surface at a low strength |
| A. |
Surface may not have been cleaned properly. A good indication of this would be little bits of concrete stuck to the bottom of the disc. You may also not have a level surface. |
| |
|
| Q. |
When doing a test to check bonding strength on a roadway, do you have to take the test to failure? |
| A. |
Yes and no. Make sure you follow the specs for each job you do, some may want you to take it failure, while others may want you to just take it to a certain strength. |
| |
|
| Q. |
When I crank the handle down, the gauge does not move. |
| A. |
Chances are you need to fill the puller with oil. |
| |
|
| Q. |
How much epoxy do I put on the bond disc? |
| A. |
You need just a thin layer, about 3 for 4 sheets of paper. |
|
