Home > Strength Testing >

Test Anvil for Calibrating James Test Hammers
Test Anvil for Calibrating James Rebound Hammers
Test Anvil for Calibrating James Test Hammers


 
Questions?
Call us for more information!
Price $965.00

Product Code: W-C-7312
Qty:

Product Information
 


Purchasing Notes


It is recommended that calibration of the test hammers be checked regularly usually after about 2000 strokes.The James Calibration Anvil (W-C-7312) has been designed for just that purpose.

The Calibration Anvil weighs approximately 35 lbs.(16kg) and should be ordered separately.


Specifications

Weight: 2 lbs (0.9 kg)

Size: 10 1/2" (267mm) (with plunger retracted)

Shipping Weight: 6 lbs. (2.7 kg)

Carrying Case: 15 1/2" x 11 1/2" x 2 1/2"

Dimensions: (394 x 292 x 64 mm)


Frequently Asked Questions

Q. Unit gives low or high readings

A. Unscrew cap on top of unit, there is a screw in the cap. Adjust the screw up or down and check reading against test anvil.


Q. Unit will not fire when depressed

A. Make sure cap screw is in the proper position. Check to make sure trigger spring is present. Check for plunger spring in tip.


Q. My first reading was very low, but the readings after that are consistent

A. Disengage hammer and let it sit before taking your first reading.


Q. How many readings should I take in one particular area?

A. You should take 10 readings, if you have any large deviation, exclude them and take additional readings.


Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Strength Testing
Strength Testing > Rebound Hammers > Digital Rebound Hammer
Strength Testing > Rebound Hammers > Manual Rebound Hammer
Strength Testing > Rebound Hammers > Digital Rebound Hammer > Accessory
Strength Testing > Rebound Hammers > Manual Rebound Hammer > Accessories
Strength Testing > Rebound Hammers