Home > Strength Testing >

Test Anvil for Calibrating James Test Hammers

Test Anvil for Calibrating James Rebound Hammers
Test Anvil for Calibrating James Test Hammers


 
Questions?

Contact us for more information!


Get a Quote!!
Price $1,128.00


Product Code: W-C-7312
Qty:

Product Information
 


Purchasing Notes


It is recommended that calibration of the test hammers be checked regularly usually after about 2000 strokes.The James Calibration Anvil (W-C-7312) has been designed for just that purpose.

The Calibration Anvil weighs approximately 48 lbs.(22.23 kg) and should be ordered separately.


Specifications

Weight: 49 lbs (22.23 kg)

Physical Size: 9.5" H x 6.0" dia. (241 mm H x 152.4 mm dia.)

Shipping Weight: 51 lbs. (23.1 kg)

Hardness of Insert: 65-67 HRC


Frequently Asked Questions

Q. My Test Hammer gives low or high readings

A. Using the Calibration Test Anvil as a reference, find the rebound number on the Test Anvil. If the number is 80 +/- 2, the Hammer calibration is good. If not, the Hammer needs to be adjusted. With the impact plunger out, remove the rear cap on the Hammer. There is a screw with two locking nuts in the cap. Adjust the screw position up or down accordingly, and recheck the rebound reading against the Calibration Test Anvil. When properly adjusted, be sure to tighten down the locking nuts in the cap. The Hammer is now ready to be used again.

Q. What if I have a Low Impact Test Hammer (W-M-255)

A. The Low Impact Test Hammer is calibrated in a similar way. The rebound number for this Hammer should be 75 +/- 2 on the Calibration Test Anvil.


Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Strength Testing
Strength Testing > Rebound Hammers > Digital Rebound Hammers
Strength Testing > Rebound Hammers > Manual Rebound Hammers
Strength Testing > Rebound Hammers > Digital Rebound Hammers > Accessory
Strength Testing > Rebound Hammers > Manual Rebound Hammers > Accessories
Strength Testing > Rebound Hammers